Hunter node-100 manual turn on

Hide thumbs Also See for Node : Instructions 3 pages. Table Of Contents. Table of Contents.

Manual Watering allows the user to activate a single station for a specified run time or activate an entire program. The weather sensor condition if used will be disregarded in the manual single station mode. Contact Support. Node - Manual Watering. Press and hold the right arrow button until the icon is displayed. The station number will be displayed in the lower left side of the display along with the run time. Use the left arrow and right arrow buttons to select the desired station and then quickly press the plus or minus buttons to set the manual watering time for the station shown.

Hunter node-100 manual turn on

.

Press the button until the icon is displayed. Rename the bookmark. Upload manual.

.

This section provides an overview of some of the components of the NODE. Each item will be discussed in further detail later. However, this section can be helpful in getting acquainted with the different options available. The NODE uses one or two standard nine-volt batteries not included to operate the valves and program the controller. The controller can operate using either a single nine-volt battery or using two nine-volt batteries. Under normal conditions, the expected life is one year for a single battery and two years when using two nine-volt batteries. This allows the battery to be removed without losing program information. The NODE is provided with a solenoid attached to the controller.

Hunter node-100 manual turn on

Table of Contents. Available languages. Quick Links.

Talk quesada

We're here. Contact Support. Pressing the left arrow button when a station is running in manual watering will stop the irrigation on the current station and revert to the previous station. The purpose of this sensor is to stop watering when snap. If something is flashing on the display then permanent memory in the controller, to be restored at any time. Page Troubleshooting Guide Faulty solenoid. Verify that controller is programmed for start at start time. The controller will display a countdown and activate desired station. The station number will be displayed in the lower left side of the display along with the run time. Tell us what you need support with and we'll find the best solution for you. Previous Page. Each item will be discussed in further detail later.

Welcome to the NODE irrigation controller support section.

NOTE: Pressing the plus or minus buttons when a station in running in manual watering will modify the irrigation time for that station. Upload from disk. The station numbers are identified on the face of the NODE. The controller can Unscrew the rear body of the NODE body to gain access to operate using either a single 9-volt battery or using two 9-volt the battery compartment. The controller will display a countdown and activate desired station. Table Of Contents. We're here. A protective rubber cover is provided to prevent dirt from weather conditions dictate. The purpose of this sensor is to stop watering when snap. Still need help? Upload manual. Delete from my manuals? Incompatible solenoid. Next article Turning the System Off.

2 thoughts on “Hunter node-100 manual turn on

  1. In my opinion you are not right. I can defend the position. Write to me in PM, we will talk.

Leave a Reply

Your email address will not be published. Required fields are marked *