How to replace a lawn mower pull cord

Eventually, you're lawnmower pull cord will break. Fortunately it's an easy fix. Check out this video on how to fix

This DIY lawn mower repair guide has instructions for how to replace a lawn mower starter rope. Over time, the starter rope can wear out and eventually break, and the mower won't start. You can replace a broken recoil starter rope with a manufacturer-approved replacement part by following the steps below. Remove the dipstick tube from the engine and plug the hole with a paper towel to keep debris from falling into the engine. Remove the bolts securing the blower housing to the engine and remove the housing from the engine.

How to replace a lawn mower pull cord

Lori Irby loribirby. Posted: Sep 1, I had taken it to the mower shop and they were going to charge me just to tell me how to do it. Sep 4, by Lori Irby. Daryl Metzler djmetzle. The cord should be sold as a replacement unit. The cord attached to the top of the stator under the top cover. Find a replacement and refer to Toro's website for a repair guide specific to your model of mower. John Southall redlinepc. Posted: Jan 25, Most push and self propel lawn mowers have the pull cord assembly attached to the top of the mower by small bolts.

Main causes: drive control cable failure, worn or broken drive belt, bad transmission, broken drive wheel….

.

With perfect weather, you plan to go out to give your lawn a nice trim. You use a push mower that has never let you down in all these years. The other end is spinning back into the starter assembly. You are not the only one with this problem. It occurs more frequently with older lawnmowers, and in most cases, you have to replace the pull cord. Your machine will be up and running again soon.

How to replace a lawn mower pull cord

By: Author John Cunningham. Replacing a pull cord can be challenging, especially if the recoil spring gets loose. Taming a recoil spring can be like herding cats. Replacing the cord requires the removal of the pull start assembly. Some manufacturers, like Honda, make it easy. Other mowers may take a little more work. If your spring is damaged or unravels, go ahead and buy a whole spring and pulley.

Autopsy of kobe bryan

I watched a video on u tube and TADA!! Before you put the new pull cord in, make sure to rewind the spring and either clamp it or use a screwdriver to hold it while you get the rope. Once you get it, let the spring loosen the wheel. Most of the time, however, the cord will break at the handle. Slide the rope through the hole in the engine cover. August 11, Reconnect the spark plug wire. After removing the recoil, remove the broken cord. While holding the rope, remove the screwdriver from the holes in the pulley and housing, and let the rope slowly rewind. Remove the screws securing the engine cover to the engine. Go ahead and remove the cord. Inspect the starter pulley and remove any remaining starter rope.

At some point, all household maintenance tools are subject to wear and tear, and your lawn mower is no exception. A broken lawn mower pull cord is a pretty common problem. And fortunately, it is easy to get done DIY.

Remove the old lawnmower pull cord from the handle, feed through the new cord and tie a simple knot. When doing this, the spring will most likely unwind. Pull the handle until the knot you just tied locks into place in the recoil pulley. Learn More. Remove the engine cover. View Statistics:. Main causes: engine needs tune up, dirty or clogged carburetor, damaged flywheel key…. Email Required Name Required Website. Fortunately it's an easy fix. Read more.